3DSettings
← All settings Official Bambu
SUNLU PETG @BBL A1M 0.4 nozzle
Bambu Lab A1 mini · PETG · Bambu Studio
Original profile: SUNLU PETG @BBL A1M 0.4 nozzle · AGPL-3.0
Brief settings
- Nozzle °C 245
- Bed °C 60
- Fan min % 10
- Fan max % 30
- Max volumetric mm³/s 9
- Filament type PETG
When to use
- Start with moderate fan; too much cooling can weaken layer adhesion.
- Watch for stringing — raise temp slightly or tweak retraction if needed.
- After importing, run a small temperature tower before long jobs.
Official Bambu Lab preset imported from Bambu Studio profiles.
Source: SUNLU PETG @BBL A1M 0.4 nozzle
Inheritance: SUNLU PETG @BBL A1M 0.4 nozzle → SUNLU PETG @base → fdm_filament_pet → fdm_filament_common
Max volumetric speed: 9 mm³/s
Detailed settings
Resolved official preset (inheritance flattened).
| Preset name | SUNLU PETG @BBL A1M 0.4 nozzle |
|---|---|
| Filament type | PETG |
| Vendor | SUNLU |
| Nozzle °C | 245 |
| Nozzle min °C | 230 |
| Nozzle max °C | 280 |
| Nozzle °C (1st layer) | 250 |
| Bed °C (hot plate) | 60 |
| Bed °C (1st layer) | 60 |
| Bed °C (cool plate) | 0 |
| Bed °C (engineering plate) | 60 |
| Bed °C (textured) | 60 |
| Fan min % | 10 |
| Fan max % | 30 |
| Fan cooling layer time (s) | 30 |
| No fan for first layers | 3 |
| Max volumetric (mm³/s) | 9 |
| Flow ratio | 0.94 |
| Density (g/cm³) | 1.27 |
| Diameter (mm) | 1.75 |
| Slow down layer time (s) | 12 |
| Slow down min speed | 10 |
| Overhang fan % | 90 |
| Compatible printers | Bambu Lab A1 mini 0.4 nozzle |
| Aux cooling fan % | 0 |
| Air filtration | 0 |
| Exhaust fan % | 70 |
| Chamber °C | 0 |